Biantie La 2Pin 8mm LED Strip Connector 20Pack

CONNECT AND RECONNECT WITHOUT RUINING YOUR STRIP The fliplatch design clamps directly onto the copper pads of your 8mm LED tape light with even controlled pressure no piercing no pad scraping no destroyed sections If you clip it on wrongsideup or reverse the polarity just lift the white latch flip the strip and try again Many users find a solid connection on the first attempt the latch design makes it forgiving when they dont 6A RATING FITS THE WIRES YOU ALREADY HAVE Rated 6A at 5V24V DC these connectors designed to handle typical LED strip loads of most singlecolor LED strip runs helps reduce heat buildup at the joint The wire slot accepts 2220 AWG twoconductor cable both solid and stranded so you can use whatever extension wire is already on your shelf Housing is made from flameretardant polycarbonate IP20 indoorrated Not for RGB 10mm or 12mm strips BUILT FOR CABINET LIGHTING SHELF STRIPS AND EVERYWHERE IN BETWEEN Clip onto LED tape inside kitchen cabinets under bathroom vanities along bookshelf edges inside closet rods beneath stair nosings or behind TV panels anywhere a soldering iron wont fit and a screwtightening connector takes too long No electrical license needed Suitable for homeowners doing weekend upgrades renters who need nondestructive installs and interior decorators setting up display case lighting WORKS WITH IP65 WATERPROOF STRIPS WITH ONE PREP STEP For nonwaterproof 8mm strips insert and clip For IP65 siliconecoated strips use a small tool eg fingernail or plastic tool to peel back the silicone over the two copper pads then insert the exposed pads clamp solidly These connectors are not compatible with 10mm strips 5050 RGB 4pin or 5pin strips or any COB strip wider than 8mm Suitable for renovation projects rental apartment lighting swaps studio lighting upgrades and holiday display setups where you need connections you can take apart and reuse next season COMPLETE YOUR LED LIGHTING SETUP IN ONE ORDER These connectors are the link between your LED st