Adafruit Audio IC Development Tools Mono 2.5W Class D Audio Amplifier - PAM8302 (1 piece)

This super small mono amplifier is surprisingly powerful - able to deliver up to 2. 5 Watts into 4-8 ohm impedance speakers. Inside the miniature chip is a class D controller, able to run from 2. 0V-5. 5VDC. Since the amp is a class D, its very efficient (over 90% efficient when driving an 8Ω speaker at over half a Watt) - making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell it got hot. There's even a volume trim pot so you can adjust the volume on the board down from the default 24dB n. This board is a welcome upgrade to basic "LM386" amps. The Aand A- inputs of the amplifier go through 1. 0uF capacitors, so they are fully 'differential' - if you don't have differential outputs, simply tie the Audio- pin to ground. The output is "Bridge Tied" - that means the output pins connect directly to the speaker pins, no connection to ground. The output is a high frequency 250KHz square wave PWM that is then 'averaged out' by the speaker coil - the high frequencies are not heard. All the above means that you can't connect the output into another amplifier, it should drive the speakers directly. Comes with a fully assembled and tested breakout board. We also include header to plug it into a breadboard and a 3. 5mm screw-terminal blocks so you can easily attach/detach your speaker. You will be ready to rock in 15 minutes. Speaker is not included, use any 4 ohm or greater impedance speaker. Output Power: 2. 5W at 4Ω, 10% THD, 1. 5W at 8Ω, 10% THD, with 5. 5V Supply 50dB PSRR at 1KHz Filterless design, with ferrite beadcapacitors on output. Fixed 24dB n, onboard trim potentiometer for adjusting input volume. Thermal and short-circuit/over-current protection Low current draw: 4mA quiescent and 0. 5mA in shutdown (due to pullup resistor on SD pin) Note: The terminal block included with your product may be blue or black.