Koch Chemie Micro CutFinish Polishing Compound with Carnauba Wax - Permanent Removal of Holograms, Fine ScratchesSanding Marks; Long Term Sealing; Non-Fugitive Silicones (250 milliliters.

MICRO CUTFINISH P3. 01 Micro Polishing Compound with Carnauba Wax MICRO CUTFINISH is the latest generation machine micropolish for the permanent removal of streaks, holograms, fine scratches and sanding marks to P3000 grain size on all paint systems (including scratchresistantwith simultaneous longterm sealing with high degree of gloss and smoothness. Through the use of highly specialised, extremely homogeneous abrasive bodies, a brilliant permanent high gloss finish is created under extreme light conditions even on dark and similarly sensitive shades. Holograms and fine scratches are eliminated mechanically and NOT, which is often the case, covered over. MICRO CUTFINISH is economical, easy to polish and to remove. Contains carnauba wax and nonfugitive silicones. CUT: 3. 2 GLOSS: 9. 5 Areas Of Use Paintwork of cars, commercial vehicles, motor cycles, etc. Recommendations For Use For optimum results we recommend using KochChemies MICRO CUT (PurplePad and an orbital polisher with forced rotation (eg Makita PO5000C, highest speed. Alternatively a rotary polisher can be used in combination with our MICRO CUT Pad. Before use, moisten dried or new pads completely with polish. With the machine switched off, apply the polish evenly over the surface to be treated and then polish crosswise with medium pressure thoroughly. Afterwards polish with low pressure. Do not use pads used with this product for other products. For nonscratch and groovefree removal of polish residues we recommend The Rag Companys Eagle Edgeless or Edgeless 300 / Edgeless 365 towels. , Warnings Shake before using. Before using, check suitability and compatibility. Do not use on hot surfaces. Protect against frost and excessive heat. Notice This product information can advise you only without obligation. Liability on the part of KochChemie cannot be derived. Please check whether the product is suitable for your application.