innomaker Raspberry Pi Camera IMX296 Sensor with Global Shutter External Trigger Stream Mode 1.58MPixel Suport up to 60fps 1456x1088 Pixels Rasp Pi 4B 3B+ 3B 3A+ CM3+ CM3 Pi Zero W

The picam-mipi296raw camera module compatible with Raspberry Pi 4/Pi 3B/Pi 3. The picam-mipi296raw sensor IMX296LLR-C is a diagonal 6. 3mm (Type 1 / 2. 9) CMOS active pixel type solid-state image sensor with a square pixel array and 1. 58 M effective pixels. This chip features a global shutter with variable charge-integration time. This chip operates with analog 3. 3V, digital 1. 2V, and interface 1. 8V triple power supply and has: - low power consumption. High sensitivity, low dark current and low PLS characteristics are achieved. (Applications: Sensing) Features: - Size: 39*39mm - Interface: RPI Camera 15 PIN FPC - Output format: Y10 - Output resolution:1456*1088 - Global shutter with variable charge-integration time Support Mode: - Mode0 stream - Mode1 fast trigger - Flash Strobe: only support stream mode - Isolated Trigger and Strobe signal ,Trigger the capture in the falling edge of external trigger signal - Driver support control feature can be get through command: v4l2-ctl -l Quick Start: step1, download from our wiki(please follow our instuction send with products) step2, "sudo nano /boot/config. txt",add "dtparam=i2c_vc=on dtoverlay=vc_mipi_imx296" to the last line. step3, "sudo nano /boot/cmdline. txt",add "cma=128M" to the last line. step4, "cd picam-mipi296","sudo chmod -R arwx *". step5, according to your hardware and sysem, select to install drivers. use command "uname -a" get kernel version. Link raspberry pi3 with system kernel 5. 4. 51,"cd Linux5. 4. 51/pi3","sudo make install","sudo make setmode0","sudo reboot". step6, "ls /dev/video*" For more information please check our wiki.