ANYCUBIC LCD UV 405nm Rapid Resin for 3D Printer-500ml/ 500g-Bottle Random Grey 500ml POT016 1

Note:Two kinds of bottles with same 500g resin will be send randomly. 0Viscosity (25C: 552. 0 mpa. sLiquid density: 1. 100 g / cm3Solid density: 1. 184 g / cm3Flexural strength: 23. 4 MpaTensile strength: 23. 4 MpaElongation frequency: 14. 2 % Precautions: 1. Storage1Keep away from light and sealed at room temperature. (Sunshine contains a certain amount of UV light which would solidify photosensitive resin. Inside the machine, the ANYCUBIC resins would not be affected for over 48 hours if it is not UV light2It is recommended to store the resin under 15C 35C in a sealed container. Avoid any dusty or moist environment. 2. Usage:1Shake well before use. Avoid any direct sunlight during usage. 2Do not put in the mouth. Keep it away from the children. 3Wear gloves before use to avoid direct contact with the skin and keep the room ventilated. 4For accidently contact, please wash by plenty of water immediately. Seek medical advice if necessary. 5Finished models are required to clean by high concentration alcohol (95%about 30 seconds and post cure process may be needed for higher hardness. 6Please filter the residual resin in vat back to the container if it would not be used over 48 hours. Polluted residual resin would cause printing issues. 3. DLP printer how to choose corresponding UV resin. Before choose the ANYCUBIC resins for your own 3D printer, please confirm that the UV wavelength of your 3D printer is 405nm. We may not responsible for any damages caused by incorrect use of the resin.