CQRobot Ocean: 10. 525GHz Doppler Effect Microwave Motion Sensor Compatible with Raspberry Pi and Arduino Board. for Industrial, Measurement, Automatic Doors, Sensor Lights, Reversing Radar, etc.

The microwave motion sensor is a microwave moving object detector which is designed according to the principle of Doppler Radar. It is widely used not only in the detection of human body, but also many other objects. It has the characteristics of long detection distance and high sensitivity, and is not limited by ambient temperature. It is widely used in industrial, measurement, liquid level, automatic door movement detection, transportation and civil fields. Note : For technical support, please refer to CQRobot Wiki to get the test code, SKU:u200e CQRSENWB01. SPECIFICATION Working Pressure : 3. 3V/5V Plus/Minus 0. 25V Working Current (CW: 60mA max. , 37mA typical Dimension: 63mm * 48mm Mounting hole size: 3. 0mm Emission Parameter Detection Range: 2 meters to 16 meters continuously adjustable (min: 2 meters, max: 16 metersEmission Frequency: 10. 525 GHz Frequency Accuracy: 3MHz Output Rate (Min: 13dBm EIRP Harmonic Emission: Less Than 10dBm Average Current (5% DC: 2mA typ. Pulse Width (Min: 5uSec Load Cycle (Min: 1% Receiver Parameter Sensitivity(10dB S/N ratio3Hz80Hz Broadband: 86dBm; 3Hz80Hz Bandwidth Clutter: 10uV. Antenna Gain: 8dBi Vertical Level: 3dB Beamwidth: 36 degrees Horizontal Level: 3dB Beamwidth: 72 degrees Ocean Wire Specifications Cable Specifications: 22AWG Material: Silicone Withstand Voltage: Less Than 50V Withstand Current: Less Than 1000MA Length: 21cm Line Sequence: RedPower Supply Positive, BlackPower Supply Negative, GreenControl Board Signal Terminal. DISTRIBUTION LIST 1 * Microwave Motion Sensor 1 * Ocean Interface JST 3Pin Cable.