Generac 7006 100 Amp Load Manager, Gray

BROAD GENERATOR COMPATIBILITY Works with any single phase standby generator that produces standard 60 Hz AC output, including Generac air cooled and liquid cooled models single phase 240V only, not for three phase systems, SCALE UP TO 8 MODULES PER SYSTEM Install up to eight 100A Load Managers on a single generator system to manage multiple large appliances independently, with each module requiring a unique priority number, WIRE FREE FREQUENCY SENSING TECHNOLOGY No control wires to the transfer switch are needed the module monitors generator output frequency autonomously and sheds loads the moment Hz drops below threshold, NEMA 3R RATED FOR INDOOR OR OUTDOOR MOUNTING Enclosure withstands rain, sleet, and ice formation across an operating range of 22F to 122F, sized at 7.0 H x 11.4 W x 5.3 D for flexible placement, 8 LEVEL PRIORITY DIAL FOR CUSTOMIZED LOAD RECOVERY Assign each module a unique priority 1 8 lower numbers recover power first after a shed event, with each step adding a 15 second staggered delay to prevent re overload, GENERATOR LOCKOUT MODE BLOCKS NON ESSENTIAL LOADS Set any module to lockout to permanently prevent that appliance from drawing generator power during an outage, while still allowing it to run normally on utility power, EXTERNAL LED STATUS DISPLAY WITH 5 CODED STATES Diagnose system status without opening the enclosure solid green means load connected, 1 second flash means startup delay, and 3 second flash means 30 minute overload lockout is active, WHAT S INCLUDED 100A Load Manager module with built in frequency sensing intelligence, priority label decal, and owner s manual no separate controller required for standalone operation